Main Menu

To access the main menu, press the left-hand function button (15).

Navigating in the menu

  • To scroll through a menu: Press the up (17) or down (12) arrow buttons.
  • To switch to a submenu: Press the red start button (16) or the right-hand arrow button (7).
  • To confirm a selected menu option: Press the red start button (16).
  • To change a menu option using the on/off switch: Press either the red start button (16), the left-hand (14) or the right-hand arrow button (7). This will also save the menu option.
  • To go back to the next highest menu: Press the left-hand function button (15) under the back arrow.
  • To leave the main menu and go back to measuring: Press the right-hand function button (6) under the Home symbol.

Menu options

  • <Measuring mode>
    Set the required measuring mode  see Overview of the measuring modes. Once you have made your selection, the measuring tool will directly switch to the selected measuring mode.
    In the <Object Detection> measuring mode, you can also set the wall type suitable for the planned measurement and the view for the measurements.
  • <Device Settings>
    • <Ruler>: Switch on/off the ruler for the measuring modes <Object Detection> (with the exception of the <Spot View>) and for the <Leakage Detection>. Using the ruler, you can determine the distance between object centres, for example. Press the right-hand function button (6) to set the ruler to zero.
    • <Display brightness>: Set the brightness level of the display backlight.
    • <Audio signals>: Switch the audio signal on or off. When the audio signal is switched on, an audio signal sounds every time a button is pressed and every time an object is found within the sensor range.
    • <Start-up settings>: Choose the settings (e.g. wall type, view, ruler) that the measuring tool starts up when it is switched on. Choose between applying the settings from the last time the tool was switched off and personalised basic settings (these are the current settings in the main menu).
    • <‎Switch off after ...‎‎‎‎>: Choose the time interval after which the measuring tool will switch off automatically if it is not in use.
    • <Language>: Select the language used in the display.
    • <Date & time>: You can set the date and time for saving images and select the date and time format. Change the coin cell  see Inserting/Changing the Coin Cell (see figure D) when the time and date can no longer be saved.
    • <Measurement unit>: Select the unit of measurement for the measuring indicators.
    • <Factory reset>: You can reset all of the menu options to factory settings. Simultaneously, all of the saved images will be permanently deleted.
  • <Device Info>
    Here you will find device information, such as the installed software version and legal information.