1. Wallscanner D-tect 200 C
2. Operation
3. Save/transfer the measuring results

Save/transfer the measuring results

Saving Measuring Results as an Image

A screenshot function is available in the <Object View>. This enables you to save measurement results as an image in order to document them or to analyse them later on.

Measure the required range as usual. Then press the screenshot button (13).

If an SD card is inserted, the images are saved on the card. Otherwise, the images are stored in the internal memory of the measuring tool and can be transferred via the USB Type-C® interface.

Data transfer via USB Type-C® interface

Open the flap for the USB Type-C® port (4). Connect the USB Type-C® port of the switched-off measuring tool to your PC via the USB Type-C® cable (23).

Switch on the measuring tool using the on/off button (8).

Open the file browser on your PC and select the BOSCH D‑tect 200 C drive. The saved files can be copied from the internal memory of the measuring tool, moved to your PC or deleted.

As soon as you have completed the required operation, disconnect the drive following the standard procedure.

Note: Always disconnect the drive from the operating system of the PC first (eject drive), as failure to do so may damage the internal memory of the measuring tool.

Then switch off the measuring tool using the on/off button (8). Remove the USB Type-C® cable (23). Close the flap for the USB Type-C® port (4) to protect it from dust or splashes.

Note: Use the USB Type-C® interface to connect the measuring tool to a PC only. The measuring tool may be damaged if connected to other devices.

Note: The USB Type-C® interface can only be used for data transfer. Rechargeable batteries or other devices cannot be charged by this interface.

Data Transfer via SD Card