Measuring Mode <Distance Measurement>
In this measuring mode, you can measure distances on the wall. It is only possible to take this measurement in a straight line in the direction of travel of the wheels.
Place the measuring tool onto the wall at the starting point for the measurement. The reference point of the measurement is always the top marking aid (1). If necessary, press the red start button (16) to delete the displayed measured value and to start a new measurement.
Move the measuring tool over the wall in a straight line in the required direction while applying uniform pressure. The distance to the starting point is continuously measured. The measured value shown on the display is the distance to the starting point for the current measurement, not the total distance travelled (as you move the tool back towards the starting point, the measured value will be smaller).
If a required distance is to be marked on the wall, mark it using the top marking aid (1).
